Blog
Technical guides for workshop and plant fit-out in Saudi Arabia: equipment selection, load planning, configuration and maintenance, from published specs.
Paint Booths and Finishing
Extraction Direction in a Custom Booth: The Part Decides
Extraction direction is one of four decisions closed before manufacture, set by the part being coated and the nature of the industry rather than by a model.
Paint Booths and Finishing
Service Clearance Around the Booth: Sizing the Room
A booth footprint is not the floor area it needs. Three uses demand space around it, and a fourth item demands a pit or an entry ramp in the floor.
Paint Booths and Finishing
Technician Working Space Allowance in Booth Sizing
Internal size does not equal part size. The item added before the chamber is fixed, and why skipping it shows up in spray quality rather than in space.
Paint Booths and Finishing
Paint Booth Heat Output Range in kcal per Hour
The heat output figure is read against chamber volume, not on its own. Four factors move it inside the published range and one governs it before all of them.
Paint Booths and Finishing
Paint Booth Internal Width to 20 Metres: What It Serves
Chamber width moves from three metres to twenty, and the gap between the ends is a difference of sector rather than of size. What sits at each end.
Paint Booths and Finishing
Booth Electrical Power Range: What Moves the Figure
The delivered range widens roughly fourfold between its ends. Five factors move a booth inside it, and one reason the higher figure is not the better one.
Paint Booths and Finishing
Specifying a 50 or 60 Hz Supply for a Paint Booth
Voltage is constant across documented models and frequency is a choice of two. Why it is asked before shipping rather than after, and what it actually changes.
Paint Booths and Finishing
Heat Pump Paint Booth: Where It Sits Among Five Systems
Five heating systems are delivered in this family and the heat pump is one of them. What decides the choice, and what the decision is actually made against.
Paint Booths and Finishing
Short Wave Infrared Curing in a Paint Booth
A delivered heating system in this family, and the basis of the water-based configuration: ten units, thirty kilowatts and a measured heat-up time.
Paint Booths and Finishing
EU3 EU4 EU5 Filter Classes: Where Each Stage Sits
Filtration in a booth is a sequence, not a part. Three stages with distinct positions and jobs, and one reason the class is set with the configuration.
Paint Booths and Finishing
Booth Walls: Insulated Panel or Galvanised Sheet
Two published wall options, each with its own place: a fifty millimetre insulated panel in three core materials, or galvanised sheet for large cabins.
Paint Booths and Finishing
Configuration Sign Off Before Manufacture: What Gets Fixed
A custom booth passes three gates before the first panel is cut: site survey, internal size, then configuration. What each one closes and what it leaves open.
A technical question about a specific machine?
Send us the dimensions and the operating conditions, and we will answer with the configuration that fits them.