Blog

Vehicle Lifts and Lifting

Articles on selecting, installing and inspecting vehicle lifts: two-post and scissor lifts, arm configuration, bay layout and cycle time.

Vehicle Lifts and Lifting

Vehicle Lift Cycle Time: Eighty Seconds Before a Tool Is Touched

Fifty seconds up and thirty down is fixed machine time per vehicle. Where it compounds, and how the same figure works as a maintenance indicator afterwards.

Vehicle Lifts and Lifting

Clear Floor Lift Bay Layout: Floor Clear, Structure Overhead

Direct or chain drive, steel wire sync, ratchet arm locks and polymer sliders. What clear floor removes, what it needs overhead, and where it does not fit.

Vehicle Lifts and Lifting

Scissor Lift Platform Sizing: Bought on Capacity, Lived on Geometry

Adjustable length from 1560 to 1760 mm, widths for heavier vehicles, and two heights that answer different questions. How to match platform to your mix.

Vehicle Lifts and Lifting

Two Post Lift Arm Configuration: Arms Decide What Fits

Stage count sets reach, pads set contact, and inner width sets access and door opening angle. The specification lines that decide your usable vehicle range.

Vehicle Lifts and Lifting

Lift Installation Requirements: What the Floor Decides

Surface mount or excavation, initial height and ramps, ceiling clearance and inner width: the four site measurements that eliminate most of the lift range.

Vehicle Lifts and Lifting

Lift Selection Comparison: Two-Post, Scissor or Four-Post

There is no best lift type, only a correct type per bay. A lift selection comparison by working height, slab demand, electrical supply and actual job mix.

Vehicle Lifts and Lifting

Lift Safety Lock Inspection: The Check With No Warning Signs

Hydraulics degrade with warning; locks do not. What a lift safety lock inspection covers, why dust changes the interval, and the anchor bolts nobody re-checks.

Vehicle Lifts and Lifting

Hydraulic Fluid Viscosity: Rise Time as a Signal

Why lifts slow in summer, how to read rise time as a diagnostic signal, where bay position matters more than fluid grade, and why heavier oil is not the answer.

Vehicle Lifts and Lifting

Two Post Lift Selection: What Stops Installations

Ceiling height, slab condition and arm geometry stop more installations than capacity does. A practical specification checklist before ordering a two-post lift.

A technical question about a specific machine?

Send us the dimensions and the operating conditions, and we will answer with the configuration that fits them.