A small or mid-size vessel puts the buyer in front of an early fact: no stock model takes the hull. The chamber here is a design project rather than a catalogue line item.
A mid size vessel paint booth is designed around the hull, and any attempt to adapt an existing model ends with a chamber the hull will not enter or one the ventilation cannot serve.
The confirmed scope first
What we supply to this sector: paint booths for ship and yacht products, built to order. Other marine workshop equipment is not listed because it is not among what we supply.
We start from that limit rather than from a promise, because buyers here compare technical submissions — and one claiming more than the supplier holds fails in technical review rather than in price negotiation.
| Input | Why it is asked first |
|---|---|
| Hull overall length, width and height | Sets internal size plus technician working space |
| How the hull enters | Determines door size and chamber position |
| Finishing material | Filter class, air capacity and heat curve |
| Your process stages | One chamber or two |
The range that takes a hull
The published range extends to 24,000 mm long, 20,000 mm wide and 6000 mm high, with air capacity reaching 190,000 m³/h and three-stage bag and high-efficiency filtration at ≥98%.
Small craft sit at the lower end and mid-size hulls at the upper end. The final figure comes from your measurement rather than from a category.
Ventilation and fire at volume
Ventilation and fire requirements for large spray chambers are stricter than for an automotive booth, and paint, solvent and stripping waste falls under the applicable environmental rules.
We meet the regulatory requirements applicable to each project, and the certificates and approvals required are supplied on request.
Frequently asked questions
What exactly do you offer the marine sector?
Paint booths for ship and yacht products, built to order. That is our confirmed capability and we do not go beyond it; other marine workshop equipment is not listed because it is unconfirmed.
Can humidity be held for marine coatings?
Yes where the material calls for it. Temperature and humidity control together is delivered on custom builds, with the range set per project from the finishing material and the part’s requirements.
Do I need a separate preparation cell?
If you strip old coating and inspect before spraying, then largely yes. Those stages carry extraction requirements different from spraying, and combining them shortchanges one of them.
How long does a chamber this size take?
Design, manufacture and delivery time is set once internal size and configuration are fixed, and it is given with the technical offer rather than before it.
Related reading
- Yacht Paint Booth
- Aircraft Paint Booth
- Helicopter Paint Booth
- Hull Coating Enclosure
- Large Enclosure Ventilation
- SASO conformity for imported equipment
What to do next
Send hull dimensions, finishing material and your process stages, and we will return a chamber concept built on your measurement. talk to a specialist. Sector detail is on the aerospace, marine and rail industry page.