A decorative joinery workshop differs from a furniture plant in one respect that changes the whole design: the pieces are long and narrow — cornices, frames, wall panels — rather than bulky.
A wooden decor finishing booth is built on the longest board rather than the largest volume, which makes length the governing figure while width and height follow.
Length first
A door, a panel, a table and a kitchen front pass down the same line at completely different sizes, and the chamber is built on the largest piece and how it is hung or placed.
The published range extends to 24,000 mm long, 20,000 mm wide and 6000 mm high, so it takes long boards comfortably — and usable volume is set by row count rather than length alone.
| Question | Effect |
|---|---|
| What is the longest piece on your line? | Minimum internal length |
| How many pieces per cycle? | Usable volume and row arrangement |
| Hung or laid flat? | Internal height and rack design |
| Which finishing material? | Heat curve and filter class |
Lower heat, not higher
Booths in this sector run a lower-temperature drying cycle suited to timber. Wood holds internal moisture, and rapid heating drives it out faster than the surface can take, so cracking or warping appears days later rather than immediately.
The practical consequence is that cycle time here is longer and its temperature lower than in vehicle refinishing — and anyone basing a throughput calculation on an automotive average will misjudge it.
Dust is generated inside
Unlike a car workshop, a joinery shop generates its own dust from sanding and cutting, and it keeps forming while work proceeds. Extraction is therefore designed to handle dust and overspray together, and separating preparation from spraying becomes a surface quality condition.
The separation is physical rather than procedural, because procedure alone does not stop dust returning to the prepared surface.
Frequently asked questions
What is the longest piece you can finish?
The published range extends to 24,000 mm long. Final size is set by the longest piece on your line and by how it enters the chamber.
Will an automotive booth do decorative timber?
The principle is the same — a controlled air and heat environment — but size, heat curve and part entry differ. That is why a timber booth is built to order around the part and the production line.
How many pieces fit one cycle?
It is set by racking and row spacing, and that spacing has to allow air to reach between two pieces. Send your target piece count so the arrangement is built on it.
What safety requirements are specific to timber?
Management of accumulated wood dust and the fire requirements attached to it, plus ventilation and disposal of finishing material and solvent waste. Details vary with the municipality and workshop location.
Related reading
- Retail Display Finishing Booth
- Timber Drying Cycle Booth
- Signage Finishing Oven
- Extraction Direction in a Custom Booth
- Wooden Door Coating Oven
What to do next
Send the longest piece on your line, pieces per cycle and the finishing material, and we will return a chamber design built on your line. talk to a specialist. Sector detail is on the woodworking and furniture page.